End Caps Made by BWF Profiles

We offer you neatly cut profiles and profiles with end caps. For more information about our cutting plastic profiles, tubes and sheets please read our website section "Cutting".

We provide you with two different kinds of end caps:

glued and milled end cap on plastic profile

1. Gluing and routing using strip profiles

This version can be realised without injection-moulded end caps. Instead, we use an extruded strip profile which is glued to the end of your profile. Afterwards, we mill the end caps flush with the profile (routing). With this method, we are able to prevent shadows on the profile caused by overlaps and also comply with International Protection Codes in terms of splashing water.
 

ultrasonic-welded endcap on plastic profile

2. Gluing and ultrasonic-welding of injection-moulded end caps

We also provide you with injection-moulded end caps, which we either glue to the end of your profile or combine using ultrasonic-welding. The latter method is not only fast, but also very cost-efficient for larger quantities.
 

We are looking forward to finding and producing the perfect end cap for your profile. Please use our contact form or address your contact person directly. Specific inquiries can be forwarded using our request form.